LEGRAND VANTAGE CC-STAT - Page 7

7
No: IS-0685 – Rev. 2
TEMPERATURE AVERAGING (continued)
POWER AND RESET OPTIONS
Connect multiple thermostat sensors for temperature averaging. Only 4 or 9 sensor congurations are allowed for averaging. Only
wire multiple sensors as shown.
NINE SENSOR TEMPERATURE AVERAGING – SCHEMATIC
9 Sensors (see additional information shipped with sensor)
NOTE: Temperature averaging using the CC-TEMPSUP support module’s built-in temperature sensor allows averaging 2, 3, or 4
sensors. See additional instructions packaged with support module.
The InFusion System retains settings in the event of a power outage. When power is restored, all settings, including Network
Override aka Occupied/Unoccupied modes are restored. The reset* button located under the battery cover can be used to reset the
thermostat to factory defaults.
CAUTION: Thermostat power must be cycled after a reset for the CC-WLINT or CC-RLINT stations to operate correctly.
2-WIRE THERMOSTAT CABLE
R=RED • W=WHITE
W
R
W
R
B+ A+ B- A- C B O Y Y2 G RC RH W2 W R S2 S1 T1 T2 RSB RSA
R
W
S1 S2 S3
T1
T2
R
W
R
R
W
W
R
W
R
W
W
R
W
R R
W
W
R
W
W
R
W
R R
W
S4 S5 S6
S7 S8 S9
R
R
R
W
W