Unity Motorhome
44
Vehicle Operation
2
Do NOT drive your motorhome with the slide
out room extended. This is dangerous and
contravenes all North American trafc laws.
Make sure all bystanders are clear of the
area before operating the slide out room
controls. Ensure that travel locks (1) are
removed before extending the slide out
room, and ensure travel locks are installed
before moving the motorhome.
Extending the Slide Out Room
The slide out control switch (2) is located in the
cabinet above the coach entrance doorway.
Depress and hold the bottom of the slide out
control switch (2) until the slide out room is fully
extended,then release the switch. Fully extend
the slide out room to ensure the all-weather
seals are in correct alignment.
Retracting the Slide Out Room
Depress and hold the top of the slide out
control switch (2) until the slide out room is fully
retracted, then release the switch. Fully retract
the slide out room to ensure the all-weather
seals are in correct alignment.
Servicing All-Weather Seals
Cracked or worn all-weather seals around the
slide out room may allow dirt and moisture
to enter your motorhome which could lead to
premature interior wear. Inspect the all-weather
seals in the spring and fall, and have them
replaced if necessary.
Extensive travel and use in severe weather
conditions may cause more rapid deterioration
of some components, especially all-weather
seals.
1
Warning
Danger
Have professional service personnel, adjust,
maintain, and replace the all-weather seals to
extend the life and comfort of your slide out
room.
1
To Next Page
Loading...