Unity Motorhome
95
Water and Plumbing System
5
NOTICE
After connecting to the external water
supply, open the faucets in your motorhome
slowly and cautiously. Air trapped in the
line can cause the water to splash into the
sink. Drape a washcloth over the faucet to
prevent excessive splashing.
Disconnecting the External Water Supply
1. Turn off the city water supply.
2. Relieve the water pressure in the line by
opening a faucet in the motorhome.
3. Disconnect the hose from the city water
connection (1).
4. Replace the protective plug (not shown)
over the city water connection (1).
Filling the Fresh Water Tank
City Water
1. Connect the water hose to the city water
connection (1).
2. Turn the water ll selector valve (2) to water
tank ll (A).
3. Turn on the city water supply.
4. Depress and hold the fresh water tank level
switch (3) to show the percent-full level on
the LED display (4). Once the fresh water
level reads full on the LED display, turn off
the city water supply.
5. Turn the water selector valve (2) to the city
water position (B).
6. Turn on the water pump switch (5) on the
system monitor panel in the cabinet above
the coach entrance doorway.
7. Slowly open the cold water tap until the
water runs smoothly. Repeat with the hot
water taps.
4
3
B
A
2
1
To Next Page
Loading...