Unity Motorhome
64
Appliance and Equipment Operation
Leisure Lounge Plus System (optional)
Lowering the Murphy Bed
1. Refer to the Slide Out Room section in the
“Vehicle Operation” chapter in this manual
for details.
2. Raise the table (1), secure in upright position
with latch (3), fold support/small table (2).
3. Ensure lounge chairs are in the fully upright
position using recliner buttons (4) on the
side of the chair.
4. Rotate lounge chairs so they are facing
away from bed by lifting and holding the
lock button (5) while you swivel the seat.
Release the lock button when the chair is
slightly rotated to ensure the seat locks into
the next position.
5. Remove the lounge chair seat back
cushions and headrests, and fold the seat
backs forward until they lay at (6).
6. Release the locks on both sides of the
Murphy bed (rotate to unlock).
7. Slowly and carefully lower the Murphy bed.
Ensure the Murphy bed locks into place
once fully lowered by lifting slightly on the
side of the bed. If bed is not locked, sit on
corner of bed to apply additional downward
pressure.
8. Lower step cover (7). Refer to the Step
Cover section in the “Vehicle Operation”
chapter of this manual.
3
2
4
5
6
7
1
To Next Page
Loading...