For the link to the safety data sheets internet connection required.
2.5 Operating Safety
• Read and understand the applicable manual and all safety signs before
you connect power supplies to operate, maintain or adjust the milking
robot
• Only trained persons are permitted to operate the milking robot
• Do NOT use chlorine products in the cleaning system. Lely Industries
N.V. is not liable for, and does not cover under warranty, any damage or
harm due to the use of other cleaning products in the cleaning system
which do not meet the Chemicals Specifications.
• Do NOT mix up the chemicals when you replace the jerry cans.
• SWITCH OFF the milking robot, disconnect and isolate the electrical
power supply, release pneumatic pressure and wait for all moving parts
to stop before you clean or do maintenance on the milking robot
• Install all covers and guards before you operate the milking robot
• Keep hands, feet, hair and clothing away from all moving parts
• Keep unauthorized persons, especially small children away from the
milking robot at all times
• Before the pneumatic pressure is supplied to the milking robot, make
sure all parts are tight and that all hoses and fittings are in good condition
• Make sure the cow detection camera is free of dirt and debris
• Do not enter the operating area of the robot arm
• Do not block the robot arm. It can move with sufficient force to cause
injury to you and/or the cow
• Do not help the milking robot from the control area when it is attaching
the teat cups to the cow
• Always be alert for unexpected movement of the cow. Cows can transmit
large forces to parts of the machine
• Do not look directly into the laser light of the sTDS
• Keep the working area as clean and as dry as possible
• Contact your nearest Lely service provider if you have any questions
• Review safety related items with all operators frequently (annually).
2.6 Installation Safety
• Do not install the tubular fencing on the cow side of the robot unit before
the robot unit is in the correct position.
• The robot unit weighs approximately 650 kg (1433 lb) and the central unit
weighs approximately 320 kg (705 lb). Always use the correct lifting
equipment when you move the robot unit or central unit.
• Read and understand the instructions in the Building Specifications
Manual and Installation Manual.
• Use the special carrying frame when a fork lift truck is used to transport
the robot unit.
Safety Instructions
2-3
5.1004.8506.0 -
To Next Page
Loading...
Need help?
General