5.4101.8538.0 B
M12 Connectors 8-3
3. Put the bit (3) of the M12 torque tool on the connector (2) (see figure 26 on page 8-3).
Figure 26. Connect the M12 connector
KEY: 1. Torque screwdriver - 2. Connector - 3. M12 torque bit
4. Turn the torque screwdriver clockwise until you hear a clicking sound.
5. The M12 connector is now tightened to 0.4 Nm.
Disconnect
To disconnect the M12 connectors:
1. Remove the M12 torque bit from the torque screwdriver (see M12 Torque Tool on page 8-1).
2. Turn the M12 torque bit.
3. Replace the M12 torque bit on the torque screwdriver.
4. Put the bit (3) of the M12 torque tool on the connector (2) (see figure 26 on page 8-3).
5. Turn the torque screwdriver counter clockwise to loosen the M12 connector.
6. Remove the M12 connector.
in n o vato rs in ag ric u lt u re
To Next Page
Loading...
