EasyManua.ls Logo

LENCO BearCat - Stationary Elevated Idle Control

LENCO BearCat
66 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
31
Note: Do not operate the wipers on a dry windshield. is may scratch the Ballistic Glass, damage the wiper blades or
cause wiper motor transmission damage. Always use the windshield washers before wiping a dry windshield.
Rotate the end of the control:
• Away from you to increase the wiper speed
• Towards you to decrease the wiper speed
Windshield Washers
Note: Do not operate the washers when the washer reservoir is empty. is may cause the washer pump to overheat.
Press the end of the stalk to activate the washer.
• A brief press causes a single wipe without washer uid
• A quick press and hold causes the wipers to swipe three times with washer uid
• A long press and hold will activate the wipers and washer uid for up to 10 seconds
A wipe will occur a few seconds aer washing to clear any remaining washer uid. is feature can be turned on
and o in the information display.
Stationary Elevated Idle Control
Stationary Elevated Idle Control allows the vehicle to be in Battery Charge Protect mode (BCP) while it is idling
in a stationary position. e switch is located in the Ford auxiliary switch panel. e switch will illuminate while
in the on position.
Stationary Elevated Idle Control Switch

Table of Contents