32
e vehicle gear shi selector must be in park with the parking brake set. Flip the idle control switch up. When
activated (BCP) will regulate engine RPM based on the degree of battery charge, up to 1200 RPM maximum. e
idle control can be deactivated by releasing the parking brake, stepping on the brake pedal, or cycling the switch
down into the o position.
Once deactivated the system needs to reset by cycling the dash mounted switch while keeping the previous
parameters in place.
Driving Lights
Driving Lights are located in the front bumper and they are activated by cycling the switch labeled “Driving
Lights” upwards. e switch is located in the Ford auxiliary switch panel. e switch will illuminate when in the
on position. Vehicle main power must be “ON” for driving lights to function.
Wig-Wag Lighting
Wig-Wag Lighting is controlled by toggling the switch labeled “Wig-Wag” upwards. e switch will illuminate
when activated. Vehicle main power must be “ON” for wig-wag lighting to function. Once activated the front
headlights and rear taillights including the reverse lights will ash, alternating from side to side.
AUX 4
Note: e additional switch location, AUX 4, is not in use but is available for future accessory installation. Max power
10amps.
Wig-Wag Switch
Driving Light
Driving Light Switch
To Next Page
Loading...