EasyManua.ls Logo

LENCO BearCat - Exterior Stationary Scene Lighting; Light Bar Prep

LENCO BearCat
66 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
35
Exterior Stationary Scene Lighting
Exterior stationary Scene Lights are located at roof level on the side walls.
e Exterior Stationary Scene Lights are controlled by activating the switches in the center console labeled “LEFT
AREA” and “RIGHT AREA” into the forward position. e “Le Area” switch controls both lights on the le
side of the vehicle. e “Right Area” switch controls both lights on the right side of the vehicle. e switches will
illuminate when activated. Vehicle main power must be “ON” for scene lights to function.
Light Bar Prep
e Light Bar Prep includes a mount area that is located forward on the roof of the vehicle. Removable exterior
panels and internal access holes through the roof help facilitate wiring installation. An ATC style fuse protected
power circuit is located in the center console and is marked “Lightbar”. Locations in the center console are le
blank for installation of your light bar controls. e maximum width a light bar can be is 44”.
Typical switch conguration for optional lightbar:
Front Bar: Illuminates the front of the light bar
Rear Bar: Illuminates the rear of the light bar
Take Down/Alley: Optional Take Down and Alley Lights are available
Exterior Stationary Scene Lighting
Exterior Stationary Scene Lighting Controls

Table of Contents