Lennox 19V30 Installation And Setup Guide

53
buttons representing OPEN and SECURE wireless networks, along with
button for adding a network.
2. Select the access point that has already been established and connected.
When selecting the info icon, a screen will appear which will display an
option to forget the network and IP address assigned to the thermostat
by your router, sub-net mask, router, DNS and RSSI. If the RSSI signal
strength is anywhere between -9 to -69, then the signal strength is
sufcient. If outside this range, then either relocate the router closer to the
thermostat, add a repeater, or move the smart hub. Adjusting antenna on
router and/or smart hub may resolve the issue.
Home Network ........................
IP address 192.168.1.4...............
subnet mask 255.255.255.0............
router
DNS
04-ISSR............................
i
forget this network
Figure 22. Verifying Signal Strength
Performance Reports
Performance reports are only available through either the consumer or dealer
web portals.
• Homeowner access is available at www.myiComfort.com.
• Dealer access is available through the Dealer Dashboard at
www.LennoxPros.com.
More information concerning Performance Reports is available in the user
guide.
Mobile Applications
iComfort Thermostat App (Homeowner)
• The free iComfort Thermostat app is available for use on iPhone
®
, iPad
®
and
Android™ devices.
• Control cooling/heating temperatures, fan operation, set programs and set
Away mode for multiple locations.
• Controls individual zone settings if system is equipped with the optional
iHarmony
®
Zoning System.
• Controls PureAir S Air Purication System
• Controls fresh air dampers and ERV/HRV when connected to ACC1 and
ACC2 terminals.
iComfort Mobile Setup App (Installer)
• The free iComfort Setup app allows the installer to commission and service
the system on any iPhone
®
, iPad
®
and Android™ device.
• Remotely turn the system on and off during setup.
Apple, the Apple logo, iPhone and iPad are trademarks of Apple Inc. registered in the US and
other countries.
Android is a trademark of Google Inc. Use of this trademark is subject to Google permission.
Notications (Service and Alert Codes)
These screens provide information on active notications and previously
cleared notications. When selecting either a cleared or active notication a
brief description and alert code will be displayed. Notications are categorized
by system, indoor unit (air handler or furnace), outdoor unit (air conditioner or
heat pump), zoning control (if installed) and thermostat.
Alert Code Types
To expand a specication notication to access a more detail description of the
alert code, press the down arrow to expand the description.
• Service Urgent alerts are displayed on Home (user) screen under the
homeowner and installer alert buttons. Service Urgent means that a service
call is needed to get the system running.
• Service Soon / Service Urgent means that the system will likely recover
on its own and no interaction is necessary. Typically, either after a specic
timer period or a specic number of instances, some Service Soon alerts
will escalate to Service Urgent.
• Service Soon alerts are found only in under the installer alert button.
• Information Only-Dealer is information only and helps Lennox interpret test
results and understand complicated behaviors. Information Only are not
reported to homeowner or dealer.
NOTE: Communication System: When communication controls are
operating in a communication system, all jumpers and links setting
on the controls are ignored. Jumpers and links setting are treated as
defaults and would only be active if the system was congured as a
non-communicating system.

Lennox 19V30 Specifications

General

Brand	Lennox
Model	19V30
Category	Thermostat
Language	English