Lennox iComfort M30 - Energy Savings Program; Enabling Energy Savings; Customizing Energy Savings Settings

24
Touch custom to access the Set Date
Tool screen to input custom date settings.
Energy Savings
NOTE: This feature require XX.XX.xxx or higher.
Go to menu > settings > general >
about to verify your thermostat rmware
version.
Energy Savings feature is currently a feature re-
quirement for the State of California. Enrolling into
the energy saving program will allow your utility
company to control your thermostat during peak
energy events. An icon on the home page will in-
dicate when the system is in an active energy
savings event. Enrollment is a two-step process for
consumers. The rst step requires the consumer to
register with their utility provider before the thermo-
stat settings can be enabled to take advantage of
the Energy Savings feature.
Enable Energy Savings
Go to Menu > Settings > Energy Settings and turn
on enable energy savings. This will automatically
get the required certication for your thermostat.
If enabling energy savings is successful or not
successful a pop-up screen will appear indicating
either.
NOTE: The thermostat will continue to try and
retrieve the certicate, if a failure is error
is given, we recommend you wait and try
again after 5-10 minutes.
Enroll in Energy Savings
The next screen will allow you to enroll in energy
savings. Follow the on-screen prompts to continue.
Detail on-screen instructions are provided.
Energy Savings Settings
This screen will allow you to use your energy pro-
vider’s default temperature or pricing set points. You
can also customize these settings by selecting
1. Peak load event active set-points with the
following options:
• Default
• O󰀨set.
• Custom set-points
• Peak Price event Threshold
2. Peak Price Event Active Set-points with the
following options:
• Default
• O󰀨set.
• Custom set-points
• Energy Savings Events Filter
3. Energy Savings Settings Factory Reset