30
NOTE: If you wish to see the characters you are typing,
check show password. The thermostat will support
up to a 63 character password. The password
cannot contain the % or # symbols.
3. If joining the network was successful, the access
point name will appear next to wi- networks.
1. Touch wi- network. Scroll down to others.
2. Enter new network information. You will need
the name of the access point and the type of
security being used. Select Security. Options
are: none, WEP, WPA and WPA2. If your home
Wi-Fi connection is unsecured, then Wi-FI
security must be enabled using WEP, WPA or
WPA2 via the router before proceeding. Consult
your router documentation on how to enable Wi-
Fi security.
3. Enter the password.
NOTE: If you wish to see the characters you are typing,
check show password. The thermostat will support
up to a 63 character password.
4. Touch join to complete.
5. If joining the hidden network was successful,
the access point name will appear next to wi-
networks.
Whether connecting to a visible or hidden network,
if successful, a check mark will appear above both
the router and Internet icons.
The following terminology is used:
• Received Signal Strength Indication (RSSI). This
indicates the signal strength of the Wi-Fi router
being received by the scanning device (i.e.,
smart phone). So the higher the RSSI number (or
less negative in some devices), the stronger the
signal.
• Internet Protocol Address (IP address). This is
an address assigned by your home router for
each network device (e.g., computer, printer,
thermostat).
Connection to Lennox server from your In-
ternet provider may take up to 4-5 minutes
depending on your Wi-Fi speed connec-
tion speed and how busy the server may
be.
Locate the thermostat and router away from other
devices that could possibility interfere with wireless
communications. Some examples of other devices
that could interfere are:
• Microwave ovens
• Wireless cameras
• Portable phones and bases
• Baby monitors
• Wireless speakers
• Bluetooth devices