https://www.youtube.com/watch?v=M1eiYOlW18k
Install the rubber feet
Follow instructions in this section to install the rubber feet (four rubber pads) to a node or node sleeve.
About this task
To avoid potential danger, make sure to read and follow the safety information.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
Attention:
• Read
“Installation Guidelines” on page 1 and “Safety inspection checklist” on page 2 to make sure that
you work safely.
Procedure
Step 1. Carefully place the node upside down.
Step 2. Remove the film on the rubber pad; then, stick the rubber pad onto the corner of the underside of
the node.
Figure 80. Installation of a rubber pad
96 ThinkEdge SE350 V2 Hardware Maintenance Guide
To Next Page
Loading...
