Lenovo ThinkEdge SE350 V2 - Cable Routing for the Hot-Swap Drives

Figure 103. I/O-module-board connectors for cable routing
Notes:
• Depending on the specific configuration, the I/O module board might look different from the illustrations in
this section.
Table 3. I/O-module-board connectors for cable routing
1 I/O-module-board power connector 2 Power connector for Drive Backplane 1 (lower)
Cable routing for the hot-swap drives
Follow instructions in this section to learn how to do cable routing for the 15mm and 7mm 2.5-inch hot-swap
drives.
Identifying connectors on the drive backplanes
The following illustration shows the connectors on the drive backplanes that are used for internal cable
routing.
Figure 104. Connectors for cable routing on Drive
backplane 1 (lower)
Figure 105. Connector for cable routing on Drive
backplane 2 (upper)
Table 4. Backplane connectors for cable routing
1 Drive-backplane 1 power connector
3 Drive-backplane 1 MCIOx4 connector for SATA
2 Drive-backplane 1 MCIO connector for NVMe 4 Drive-backplane 2 MCIO connector for NVMe
Chapter 2. Internal cable routing 129