Lenovo ThinkEdge SE350 V2 - I;O-Module-Board Connectors for Cable Routing

Figure 102. System-board connectors for cable routing
Table 2. System-board connectors for cable routing
1 Connector for the intrusion switch cable
*
5 Connector for the lock position switch cable
*
2 SATA connector for Drive backplane 1 (lower) 6 Connector for the front operator assembly
3 MCIO connector 1 for Drive backplane 1 (lower) 7 Power connector for the I/O module board
4 MCIO connector 2 for Drive backplane 2 (upper) 8 Connectors for fan cables
*
Notes:
•
*
For the installation or removal of the intrusion switch with cable, see
“Intrusion switch with cable
replacement” on page 60
.
•
*
For the installation or removal of the lock position switch with cable, see
“Keylock switch with cable
replacement” on page 64
.
•
*
For the installation or removal of the fan cables, see
“Fan module replacement” on page 54.
I/O-module-board connectors for cable routing
The following illustration shows the internal connectors on the I/O module board that are used for internal
cable routing.
128
ThinkEdge SE350 V2 Hardware Maintenance Guide