Figure 68. Installation of a memory module
a. Carefully press to open the retaining clip.
b.
Align the memory module with the slot.
c.
Firmly press both ends of the memory module straight down into the slot until the retaining
clip snaps into the locked position.
Step 3. If there are plans of installing additional memory modules, proceed to install all of them.
After this task is completed
• If applicable, reinstall the intrusion switch (see
“Install an intrusion switch with cable” on page 62).
• Proceed to complete the parts replacement (see
“Complete the parts replacement” on page 125).
Demo video
https://www.youtube.com/watch?v=LZDO0ecEJso
MicroSD card replacement
Follow instructions in this section to remove or install a MicroSD card from or to the system board.
Remove the MicroSD card
Follow instructions in this section to remove the MicroSD card.
About this task
78 ThinkEdge SE350 V2 Hardware Maintenance Guide
To Next Page
Loading...
