Lenovo ThinkEdge SE350 V2 - Node Component Replacement; Air Baffle Replacement

Figure 30. Installation of a power cable cover, 2U2N enclosure
c. Tighten the two screws to secure the power cable cover.
After this task is completed
• Reconnect all power cords and all external cables.
• Connect the power cords and power on the server (see
“Power on the server” on page 7).
• For the removal or installation of the enclosure from or to the rack, see
“Rack mount configuration” on
page 9
).
• For details of the rail options for the rack installation, see
“ Rail Installation Guides” on page 179.
Node component replacement
Follow instructions in this section to remove or install components from or to the node.
Air baffle replacement
Follow instructions in this section to remove or install an air baffle.
Remove the air baffle
Follow instructions in this section to remove the air baffle.
About this task
To avoid potential danger, make sure to read and follow the safety information.
• S002
32
ThinkEdge SE350 V2 Hardware Maintenance Guide