7mm SATA drives
Figure 107. Backplane power cable and SATA cable for the 7mm drives; Drive backplane 1 (lower)
Cable
From To
1
Drive-backplane 1 power connector
Power connector for drive backplane on the I/O module
board
2
Drive-backplane 1 MCIOx4 connector for SATA SATA connector on the system board
Attention:
• Make sure that all cables between the drive backplane(s) and the system-board connectors go through
the cable wall on the power module board.
• For a better result of cable routing, install the cable of the keylock switch before connecting the drive-
backplane power cable (
1 ) (see “Install a keylock switch with cable” on page 66).
Chapter 2. Internal cable routing 131
To Next Page
Loading...
