Figure 44. Installation of the drive cage
Step 3. Tighten the four screws as illustrated.
Figure 45. Installation of the drive cage screws
After this task is completed
• Connect all necessary cables to the drive backplane(s) (see
“Cable routing for the hot-swap drives” on
page 129
).
Attention: Before connecting the drive-backplane cables, make sure that the power input board module
and the power module board are installed in place.
• Install the top cover to the node (see “Install the top cover” on page 124) or install the node into an
enclosure (see
“Install a node to the rack” on page 16).
Chapter 1. Hardware replacement procedures 51
To Next Page
Loading...
