Lenovo ThinkEdge SE350 V2 - Page 64

https://www.youtube.com/watch?v=PDgiyW3qFoY
Install a fan module
Follow instructions in this section to install a fan module.
About this task
To avoid potential danger, make sure to read and follow the safety information.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
• S017
CAUTION:
Hazardous moving fan blades nearby. Keep fingers and other body parts away.
Attention:
• Read
“Installation Guidelines” on page 1 and “Safety inspection checklist” on page 2 to make sure that
you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
node; then, remove it from the package and place it on a static-protective surface.
Procedure
Step 1. Align the fan module with the slot in the fan cage and make sure that the fan cable is on the same
side of the connector of this fan slot.
Step 2. Install the fan module into the fan cage.
a.
Place the fan module into the slot; then, press it down into place.
b.
Connect the fan cable to the connector on the system board.
56
ThinkEdge SE350 V2 Hardware Maintenance Guide