Figure 57. Installation of the keylock switch with cable onto the bracket
Step 2. Install the keylock switch with cable to the node.
a.
Hook the keylock switch onto the pin on the sidewall of the node; then, slightly push it
leftward.
b.
Tighten the screw to secure the keylock switch.
c.
Connect the keylock switch cable to the system board.
Figure 58. Installation of a keylock switch with cable
After this task is completed
• Reconnect the drive-backplane power cable to the I/O module board (see
“Cable routing for the hot-swap
drives” on page 129
).
• Proceed to complete the parts replacement (see
“Complete the parts replacement” on page 125).
Demo video
Chapter 1. Hardware replacement procedures 67
To Next Page
Loading...
