Table 26. Removal steps of LCD unit (continued)
2
2
3
When installing: Make sure that the connectors are attached firmly to the
system board.
In step î4î, release wireless antenna cables from the cable guides.
4
4
4
4
4
4
4
4
4
4
4
When installing: Make sure that the cables are attached to the cable guides
firmly .
Attention: When you route the cables, make sure that they are not subjected to
any tension. Tension could cause the cables to be damaged by the cable guides,
or a wire to be broken.
Removing and replacing a FRU 107
To Next Page
Loading...
