3.Removetheservercover.See“Removingtheservercover”onpage65.
4.Locatetheeasy-swap-drivemodule.See“Servercomponents”onpage25.
5.Removealltheinstalledeasy-swapstoragedrivesanddummytrays(ifany)fromthehard-disk-drive
bays.See“Installingorreplacinganeasy-swapstoragedrive”onpage140.
6.Disconnectthesignalcableandpowercablefromthesystemboard.
7.Pressthetwolatches1inthedirectionasshownuntilthelatchesaredisengagedfromthechassis.
Carefullyliftthemodulestraightupalittlebitsothatthesmallhooksonthechassisarealignedwith
thecorrespondingholesinthemodule.Then,movethemoduletotherearofthechassistorelease
themodulefromthehooks.
Figure129.Removingtheeasy-swap-drivemodule
8.Touchthestatic-protectivepackagethatcontainstheneweasy-swap-drivemoduletoanyunpainted
surfaceontheoutsideoftheserver.Then,removethenewmodulefromthepackage.
Note:Carefullyhandlethemodulebyitsedges.
9.Notetheorientationofthenewmodule.Ensurethatthesmallhooks1onthechassispassthrough
thecorrespondingholesinthenewmodule.Then,carefullypressthenewmodulestraightdown
sothatitissecuredbythelatches
2.
Figure130.Installingtheeasy-swap-drivemodule
Chapter6.Replacinghardware149
To Next Page
Loading...
