Lenz Digital plus SET-01/4 User Manual

Information SET-01 51
DIGITAL plus
14.2.2 Which locomotive decoders can have their settings
changed with PoM?
All Digital plus locomotive decoders from the XF and XS series on
can use PoM. If you use locomotive decoders from other
manufacturers, please refer to their manuals for compatibility with
PoM.
Locomotive decoders that do not use PoM, are programmed on a
special programming track. For more information on this, see the
section "Programming on the Programming Track" starting on
page 54.
14.2.3 Programming a numeric value into a CV — step by
step approach:
In the following example we will change the acceleration delay on a
locomotive with address 3 using PoM:
FF Before you switch to PoM, you must call up the
address of the locomotive whose settings you want to change!
Press On the display you see Explanation
Call up the locomotive whose
settings you want to change using
PoM
Display shows the most
recently selected menu
Page with the ‘-’ key until the “CV”
display is shown.
Now enter the number of the CV
whose value you want to change.
The value for the acceleration
delay is stored in CV3
Enter the value that you want to
write into the CV
If you make a mistake, you can use
‘Cl’ to erase the last digit.

Lenz Digital plus SET-01/4 Specifications

General

Brand	Lenz
Model	Digital plus SET-01/4
Category	Control Unit
Language	English