Lenz Digital plus SET-01/4 User Manual

68 Information SET-01
Following are the settings that you can change within the "SYS_1"
menu.
15.2.1 SET_1: Setting the function of the ‘Stop’ key
You can use this system setting to configure the operation of the
'St' Stop key.
the locomotives are
stopped, but the power to
the track remains on
or the power to the track is
turned off
To configure this setting go to the SET menu:
Press On the display you see Explanation
You reach this display by
pressing 'F' followed by '9'
followed by '1'.
By pressing the '1'key, the current
setting is shown. (stop is the
factory default.)
With the ‘+’ (or ‘-’) key you can
change the setting of the mode of
'St' key.
'Enter' confirms the change, ‘Esc’
lets you leave the menu without
changing the setting.
You leave the system menu with
‘Esc’, which takes you back to
selecting the settings.
With another ‘Esc’ you return to
controlling locomotives.

Lenz Digital plus SET-01/4 Specifications

General

Brand	Lenz
Model	Digital plus SET-01/4
Category	Control Unit
Language	English