Lenze 520 Series - Test and Diagnosis Connector Xl

4(1 - DL Uflopper bZ(J series
9.3. TEST AND DIAGNOSIS CONNECTOR Xl
Test connector of the conirol board 5024 (16-pole DIP socket).
At the front side, a 16-pole socket is installed for test and diagnosis purposes.
Pin Assigmient Current
capacity
input/output
resistance
minimum
bad resis.
Vottage uhen
activated
Exptanation
1 +Vcc < 5OmA 1) ~15V ± 5% positive etectronic suppLy
2 -Vcc < 50n~ 1> -15V ± 5% negative electronic suppty
3 Term. 40 ca. lOkOhm 0.. .±10V Input for externat
current reference
4 Vp~j~ 100 K 0.. .±10V Input vottage of putse-width
modutator
9 VA = f(V~~)
5 Term. 17 < 1mA + Vcc ControLLer enable
6 ~ref 1 ca. 5OkOhm -10V to +10 standard speed reference
Inref nom‘ <‚ov
~ %ctuaL ca. SOkOhm -10V to +10 standard actuat speed
I~actuaI. nom‘ <10V
8 GND Etectronic ground
9 Term. 44 ca. 200 Ohm 10V ± 2% Speed controtler output
10
1actuaL ca. 350 Ohm 5V = 1.6 IN Actuat current
11
12
Term. 38
n.c.
ca. 5OkOhm 10V additionat speed reference
input
13 n.c.
14 Ter. 19 < 20mA 1) +Vcc for is in case of fautt
15 +I~.~<-
Limit
< lmA + 10V ± 2% Reference for positive 1
Limit
< 1n~ + 10V ± 2X Reference for negative I~<
Limit
1) including current capacity at the terminal board of the control boa rd.
Note: These ~ata are vaUd. wh~r~ the conditions ~ccording to the techr~ical
descnption ~re observed.
Lenze
67