Appendix
10-73
BA9300POS EN 2.3
10.5 Glossary
Term Meaning
CE Communauté Européenne (English: European Community)
Code For entry and display (access) of parameter values.
Variable addressing according to the format ”code/subcode” (Cxxxx/xx).
All variables can be addressed via the code digits.
Fieldbus For data exchange between superimposed control and positioning control, e.g. InterBus-S or PROFIBUS DP
GDC Global Drive Control (PC-program (Windows) for Lenze controllers)
RFG Ramp function generator
INTERBUS Industrial communication standard to DIN E19258
Select target position The target which is to be approached by means of a defined traversing profile.
LECOM Lenze Communication
LU Undervoltage
OU Overvoltage
PC Personal Computer
PM Permanent magnet
QSP Quick stop
Ctrl. enable Controller enable
Ctrl. inhibit Controller inhibit ( = Controller enable )
Contouring error Deviation between momentary position setpoint and actual position. Display for a momentary following error under C0908.
Contouring error tolerance If the contouring error reaches a defined contouring error tolerance, a fault indication is released.
Contouring error monitoring Monitors the momentary following error if the contouring error tolerance is exceeded and releases a fault indication, if necessary.
To Next Page
Loading...
