Lenze 9300 - Commissioning Sequence

Commissioning
5-4

BA9300POS EN 2.3
5.3 Commissioning sequence
Controller
Switch on
Chapter 5.4
Parameter set
already generated?
Switch on PC,
start GDC
Chapter 5.5
Parameter set
Generation
Chapter 5.6
Program control
Chapter 5.10.4
Adapt controller to the
mains
Chapter 5.6.1
Adapt controller to the
motor
Chapter 5.6.2
Enter
machine parameters
Chapter 5.6.3
Enter positioning
profile parameters
Chapter 5.8.1.3
Load
parameter set
Chapter 5.9
yes
no
A positioning already
used is to be set up
again
Anew
positioning
is to be entered
Manual homing
Chapter 5.10.3
Manual control
Chapter 5.7
Manual control
Chapter 5.7
Fig. 5-2 Commissioning sequence
Show/Hide Bookmarks