Lenze 9300 - Page 183

Appendix
10-76

BA9300POS EN 2.3
L
LECOM, Status word C0150, 8-2
Legal regulations, 1-2
Liability, 1-2
Load, parameter set, 5-21
M
Mains, Controller adaptation, 5-6
Mains conditions, 4-12
Mains connection, 4-13
Fuses, 4-14
Mains filter, 3-7
Mains types, 4-12
Maintenance, 9-1
Manual homing, 5-25
Manual positioning, Parameter, 5-9
Manufacturer, 1-2
Mechanical installation, 4-1
Message, 7-2
Messages, Error, 8-5
Monitor output, 4-21
Monitoring, 7-2
FAIL-QSP, 7-2
Message, 7-2
Monitoring functions, 7-4
Reactions, 7-2
Set reactions, 7-3
Warning, 7-2
Motor
Controller adaptation, 5-7
Selection list, 10-66
Motor cable, Shielding, 4-15
Motor connection, 4-15, 4-16
Motor protection, 4-11
N
Notes on operation, 6-2
O
Operation, 6-1
Oscillations, 4-1
Outputs
Analog, 4-21
digital, 4-21
Overspeeds, 2-2
P
Packing list, 1-1
Parameter
Enter into program set, 5-19
Homing, 5-24
Manual positioning, 5-9
Positioning profile, 5-13
Parameter set, Generation, 5-6
Parameter set transfer, 2-2
Password protection, 5-30
PC, Switch on, 5-5
PC program, Global-Drive-Control, 10-1
Positioning profile
Assembly, 5-15
Enter parameters, 5-13
Positioning program, Processing a program set, 5-18
Power connections, 4-13
Max. permissible cross-sections
for mains connection, 4-13
for motor connection, 4-17
Processing, a program set, 5-18
Program control, 5-26
Program set, Enter parameters, 5-19
Protection against contact, 4-10
Protection against inverse polarity, 4-20
Protection of devices, 2-2
Current derating, 6-3
Protection of persons, 2-2, 4-9
Insulation, 4-10
Residual-current circuit breaker, 4-9
Punching, 4-3
Show/Hide Bookmarks