Commissioning
5-14
BA9300POS EN 2.3
5.8.1.1 Tools for editing
For a simple and fast input of parameter data, GDC provides tools for editing. These are explained
in the PS templates displayed in the program.
1232
4
5
6
7
8
9
13 12 11
10
Fig. 5-10 Editing tools for the program sets
Field
Function Description
1, 3 Selection of a PS Click on ”Go to ...” (3). The dialog box (1) is opened. Select a PS which you want to modify. At
the same time you can write notes about the PS. For this, click on ”Documentation” (13) (see
also 7).
2 Browsing the PS Select the previous or next PS or jump to the first or last PS.
4 Insert PS Inserts a new PS at this place and displaces all following PS by one position. The last PS is
deleted.
5 Delete PS Deletes the current PS and displaces all following PS by one position.
6 Re se t PS Resets all parameters of the current PS to factory setting.
7, 10, 11,
12
Write comments on the PS Documentation of current PS. In the dialog box (10) you can enter a name for the PS (12) and
addanexplanatorytextascomment(11).
8 Print PS Output of the current or all PS to a printer.
9 Select dialog box ”Control”. Direct change to the dialog box ”Control”, e.g. to test modifications in manual operation.
^
5-11
To Next Page
Loading...
