Commissioning
5-22
BA9300POS EN 2.3
5.9.2 Load parameter set from the controller
The operating menu (Fig. 5-17) allows the loading of a parameter set
• from the controller to the PC by ”Read current parameter set from the
controller (F7)”
– C0002 offers the following options in the menu ”Parameter set management”:
1. Loading of factory setting (C0002=0)
2. Loading of customer-specific parameter set (C0002=1)
Tip!
The RDY message is not displayed while the parameter set is loaded since the controller cannot
be operated then.
To Next Page
Loading...
