Lenze Drive PLC - Can_Management

System bus (CAN) with Ser vo PLC & Drive PLC
System blocks
6.5 CAN_Management
6-18
L
PLC-Systembus EN 1.1
6.5 CAN_Management
System bus management (module number: 101)
• The process image for this SB is created in a fixed system task (interval: 1 ms).
With this SB
• a Reset Node can be activated to accept, for instance, changes in the baud rate and
address assignments.
• a Communication Error and Bus Off State canbeprocessedinthePLC-program.
• the transmission time of CAN2_OUT and CAN3_OUT can be influenced.
CAN_bResetNode_b
CAN_Management
C0358
CAN2_OUT
CAN_bCe2CommErrCanIn2_b
CAN_ResetNode
CAN_bTxCan2Synchronized_b
CAN1_IN
Communication Error
CAN2_IN
Communication Error
CAN3_IN
Communication Error
CAN
Bus Off State
CAN_bCe1CommErrCanIn1_b
CAN_bCe3CommErrCanIn3_b
CAN_bCe4BusOffState_b
CAN_SYNC
CAN3_OUT
CAN_bTxCan3Synchronized_b
CAN_SYNC
1
Fig. 6-9 System bus management (CAN_Management)
VariableName DataType SignalType Address DIS DIS format Note
CAN _b R es etNode_b %QX101.0.0 Execute Reset Node of the PLC
CAN_bTxCan2Synchronized_b %QX101.0.1 Transmit CAN2_OUT with
Sync telegram
CAN_bTxCan3Synchronized_b
B
l
b
i
%QX101.0.2 Trans mit CAN3_OUT with
Sync telegram
CAN_bCe1CommE rrCanIn1_b
Bool binary
%IX101.0.0
- -
CAN1_IN Communication Error
CAN_bCe2CommE rrCanIn1_b %IX101.0.1 CAN2_IN Communication Error
CAN_bCe3CommE rrCanIn1_b %IX101.0.2 CAN3_IN Communication Error
CAN _b C e4 B u sO ffState_b %IX101.0.3 CAN bus “Off State”
recognised
CAN_bResetNode_b function
A reset node is activated by setting C0358 = 1 or
CAN_bResetNode_b =TRUE.
Tip!
Even if the CAN_Management SB has not been assigned to the control configuration, code C0358
can be used to activate a reset node.
(^ 3-6)
CAN_bTxCan2Syncronized_b / CAN_bTxCan3Syncronized_b function
• FALSE: Data from CAN2_OUT/CAN3_OUT are transmitted at the end of the process image.
• TRUE: Data from CAN2_OUT/CAN3_OUT are transmitted after Sync.
– Via C0367/C0368 you can set the identifiers for the Sync transmit and receive telegram.
– The
Sync Tx Time can be set via C0369.
– Detailed information about this can be found in the description for the
CAN_Synchronization SB.
(^ 6-19)
Show/Hide Bookmarks