Lenze Drive PLC - Pictographs Used in this Manual; Terminology Used; Information about the Function Library Version

System bus (CAN) with Servo PLC & Drive PLC
Preface and general information
1-3
l
PLC-Systembus EN 1.1
1.1.3 Pictographs used in this Manual
Use of
pictographs
Signal words
Warning of
damage to material
Stop! Warns of potential damage to material .
Possible consequences if disregarded:
Damage to the controller/drive system or its environment
K
Other notes Tip!
Note!
Indicates a tip or note.
1.1.4 Terminology used
Term In the following text used for
DDS Drive PLC Developer Studio
FB Function block
GDC Global Drive Control (parameter setting program from Lenze)
Parameter codes Codes for setting the functionality of a function block
SB System block
System bus System bus (CAN): Lenze standard bus system based on CANopen
1.2 Information about the function library version
Via the global constant C_wLenzeCanDrvVersion of the LenzeCanDrv.lib function library you can
obtain information about the function library version.
• The value of this constant is a hexadecimal code. The value “16#0130” stands, for example,
for “Vers io n 1 .3”.
Show/Hide Bookmarks