Function library
Configuration of analog and digital setpoints and actual values
7−33
L
EDB82MV752 EN 5.2
) Note!
l With C0001 = 0, 1 or 2 the operation can start after the controller has been
released.
l C0001 = 3 must be set to select a setpoint via a process data channel of an AIF
bus module! Otherwise the process data will not be evaluated.
l With C0001 = 3 quick stop (QSP) is set after mains switch−on !
– PC: Deactivate QSP using the control word C0135, bit 3 = 0.
– Keypad: Set C0469 = −2−. Press
.
To Next Page
Loading...