Parameter setting
With communication module LECOM−A (RS232)
6−12
L
EDB82MV752 EN 5.2
6.3.3 Parameter setting using LECOM−A (RS232)
All codes can be accessed using LECOM-A:
Controller codes (code table: 14−10 ff.).
– These codes are automatically saved non−volatilely in the controller.
– Exception: Process data as e. g. control words or setpoints.
Module−specific codes (access via communication module only: 6−12).
The Online Help of Global Drive Control contains all notes on parameter setting with
LECOM-A.
6.3.4 Additional codes for LECOM−A (RS232)
How to read the code table:
Column Entry Meaning
Code
No. Code number (codes marked with *" are the same in all parameter sets.
Name Code name.
LECOM format Interpretation of response message:
VH = hexadecimal; VD = decimal; VS = ASCII string; VO = octet
Parameter Settings/options Contents or meaning of the parameter values (bold print = Lenze setting)
Important Important additional information
To Next Page
Loading...