Lenze E82MV152_4B

Commissioning
Parameter setting using the keypad
5−3
L EDB82MV752 EN 5.2
5.2.2 Changing and saving parameters
) Note!
l The user menu user is active after mains switching. Change to the menu all to
address all codes.
l In the different parameter sets only parameter values can be changed with the
keypad.
l Digital signals must be used to activate a parameter set for operation
(configuration with C0410)!
l In the function  the display shows the parameter set which is just active
during operation.
Step Keys Result Action
1. Connect keypad

xx.xx Hz
Function  is activated. The first code in the user menu will be
displayed (C0517/1, Lenze setting: C0050 = output frequency).
2. If necessary change to
the menu "ALL"

 Change to function bar 2
3.


4.

all Select menu "ALL" (list of all codes)
5.

 Confirm selection and change to function bar 1
6. Select parameter set for
change

 Change to function bar 2
7.


8.

1 ... 4 Select parameter set to be changed
9.

 Confirm selection and change to function bar 1
10. Inhibit controller
 
Only necessary if you want to change C0002, C0148, C0174 and/or
C0469
11. Set parameters
 
12.
 XXXX
Select code
13.
 
001
For codes without subcodes: Jump automatically to 
14.
 XXX
Select subcode
15.
 
16.
 XXXXX
Set parameters
17.
 STOre
Confirm entry if  is blinking

Confirm entry if  is not blinking;  is not active
18. Restart the "loop" at 11. or 6. to set other parameters.