Lenze E82ZAFIC001 - Conventions used; Terminology used

About this documentation
Conventions used
1
l
6
EDS82ZAFIC EN 2.0
1.2 Conventions used
This documentation uses the following conventions to distinguish between different
types of information:
Type of information Identification Examples/notes
Spelling of numbers
Decimal separator
Point In general, the decimal point is used.
For instance: 1234.56
Decimal Standard notation For example: 1234
Hexadecimal 0x[0 ... 9, A ... F] For example: 0x60F4
Binary
l Nibble
In quotation marks
Point
For example: ´100´
For example: ´0110.0100´
Text
Program name » « PC software
For example: »Engineer«, »Global Drive
Control« (GDC)
Icons
Page reference ^ Reference to another page with additional
information
For instance: ^ 16 = see page 16
1.3 Terminology used
Term Meaning
INTERBUS Fieldbus system by PHOENIX CONTACT
Standard device
Lenze controllers the function module can be used with (8200 vector, 8200 motec).
Controller
Master INTERBUS node which takes over the master function in the fieldbus system.
Slave INTERBUS node which represents a slave in the fieldbus system.
Code "Container" for one or several parameters used to parameterise or monitor the
controller.
Subcode If a code contains several parameters, they are stored in "subcodes".
In the documentation, the slash "/" is used to separate the code from the subcode
(e.g. "C00118/3").
POW Process output data word
PIW Process input data word
PCP Peripherals Communication Protocol