Lenze E82ZAFIC001 - 11 Index

Index11
l
68
EDS82ZAFIC EN 2.0
11 Index
A
Abort, 50
Ambient conditions, 14
− Climate, 14
Application as directed, 10
C
C0002: Parameter set management , 67
C1500: Software ID, 62
C1501: Software creation date , 62
C1502: Display of the software ID , 62
C1503: Display of the software creation date , 62
C1510: Configuring process input data , 58
C1511: Configuring process output data , 59
C1512: Enable process output data , 60
C1513: Response monitoring time of the PCD
communication, 61
C1514: Monitoring response to PCD communication fault,
61
C1515: Process/parameter data specification, 60
C1520: Display of all words to the master , 63
C1521: Display of all words from the master, 63
C1522: Display of all process data words, 64
C1523: Display of all process data words from the
standard device, 65
C1525: Display of the current DIP switch position (S2...S4),
65
C1530: INTERBUS diagnostics, 66
C1531: Bus counter, 66
Cable cross−sections, 24
Cable specification, 20
CE−typical drive system, 19
Code number, access via the fieldbus module, 47
Code number / Index, conversion, 47
Code table, 56
Codes, 58
− Lenze, 47
Commissioning, 26
− defining the user data length, 30
− setting for last bus node, 29
Commissioning steps, 27
Communication medium, 13
Communication Relation List (CRL), 49
Communication time, 13 , 16
Communication−relevant Lenze codes, 58
Configuration, Code table, 56
Connections, 11
Control, DRIVECOM, 42
control word, 35
Controller codes, 67
Conversion formula, Lenze codes, 47
CRL entries, 49
Cycle time, 16
D
Defining the user data length, 30
Definition of notes used, 7
Definitions, 6
Device control, Lenze, 34
Device protection, 9 , 18
Diagnostics, 54
DIP switch, S1 − setting for last node, 29
Drive profile, 13
DRIVECOM
− Bit control commands, 45
− Control word, 43
− State machine, 42
− Status bits, 46
− Status word, 44
DRIVECOM control, 42
E
Electrical installation, 19
External voltage supply, 21
F
Fault elimination, 55
Frequency setpoint, 35
G
Get−OD, 51