Lenze ECS series User Manual

Index15

476
EDBCSXA064 EN 3.2
Monitoring, 369
− absolute value encoder initialisation, 224
− AIF interface, 192
bus off, 193
time monitoring, 192
− CAN interface, timeout with activated remote
parameterisation, 204
− current load of the motor, I2 x t monitoring, 32 , 214
− FAIL−QSP, 197
− message, 197
− Monitoring times for process data input objects, 202
− voltage supply of control electronics, 221
− warning, 197
Monitoring functions, 196
− bus off, 203
− configuring, 202
− current load of controller, I x t monitoring, 211
− DC−bus voltage, 218
− earth fault, 205
− heatsink temperature, 208
− max. system speed, 227
− motor phase failure, 221
− Motor temperature, 32
− motor temperature, 206
− motor temperature sensor, 223
− Overview, 198
− Resolver cable, 222
− rotor position adjustment, 228
− short circuit, 205
− sin/cos signal, 225
− speed system deviation, 226
− temperature inside the controller, 209
− thermal sensors, 210
Monitoring of internal device temperature (OH1, OH5),
209
Monitoring of the synchronisation, 169
Monitoring times for process data input objects, 202
Monitorings
− configuration, 198
− possible fault responses, 198
MotionBus (CAN)
− boot−up time setting, 163
− CAN data telegram, 441
− CAN1_IO, 283
− CAN2_IO, 289
− CAN3_IO, 294
− cyclic process data objects, synchronisation, 450
− event−controlled process data objects, 451
− identifier, 441 , 458
− network management data, 441
− parameter data, 441 , 452
− parameter data channels, 452
− parameter data objects, addressing, 458
− process data, 441
− process data objects, 445
addressing, 458
data transmission, 448
− process data telegrams, 446
− user data, 441 , 453
Motor, connection, 62 , 70
motor, Thermal monitoring, Sensorless, 32
Motor cable length, 40
Motor cables, specification, 70
Motor data, adjusting, 366
Motor feedback system, Checking the direction of
rotation, 135
Motor holding brake
− connection, 62
− terminals, 346
Motor monitoring, 32
Motor phase failure, monitoring functions, 221
Motor protection, 37
Motor temperature, monitoring functions, 206
Motor temperature monitoring (OH3, OH7), 206
Motor temperature sensor, monitoring, 223
Motor temperature sensor monitoring (Sd6), 223
Motor, connection, , 70
Motors of other manufacturers, 132
Mounting
− axis module ECSCx..., 55
− axis module ECSDx..., 51
− axis module ECSEx..., 50
− cold−plate design, 55
− standard installation (with fixing rails), 49
− thermally separated (push−through technique), 51
Mounting position, 40

Lenze ECS series Specifications

General

Brand	Lenze
Model	ECS series
Category	Control Unit
Language	English