Lenze ECSES Series - Page 474

Index14
474
EDBCSXS064 EN 4.0
E
Earth fault monitoring (OC2), 201
Earth−fault monitoring, 201
Earthing, EMC, 51
Effecting rotor position adjustment, 151
Electrical installation, 49
− connection "Safe torque off", terminals, 74
− connection "safe torque off", 71
functional description, 72
Important notes, 73
− connection of "safe torque off"
function check, 75
implementation, 71
technical data, 74
− Connection of capacitor module ECSxK..., 64
− control connections, 65
assignment of the plug connectors, 68
Digital inputs, 69
Digital outputs, 69
− control terminals, 66
− feedback system, 86
encoder, 88
resolver, 87
− installation of a CE−typical drive system, 49
assembly, 50
earthing, 51
filters, 50
shielding, 51
− power connections, 53
connection of external brake resistor, 60
DC bus connection, 53
internal brake resistor connection, 58
motor connection, 53 , 61
motor holding brake connection, 53
plug connector assignment, 53
− power terminals
connection of motor holding brake, 62
DC bus connection, 55
− specification of the cables, motor cables, 61
Electromagnetic compatibility, 32
EMC, 32
− earthing, 51
− filters, 50
− shielding, 51
cables, 54
EMF2131IB digital frequency distributor, wire, 92 , 301 ,
304
EMF2131IB digital frequency distributor , wire, 92 , 301 ,
304
Enclosure, 32
Encoder, 88
− Absolute value encoder (Hiperface,
single−turn/multi−turn), as position and speed encoder,
113
− absolute value encoder (Hiperface,
single−turn/multi−turn), 103
− incremental encoder (TTL encoder), 89
− SinCos absolute value encoder, 90
− SinCos encoder, 90
absolute value encoder (Hiperface,
single−turn/multi−turn), 103
− supply voltage, 88
Encoder simulation, 91
Entering motor data, 145
Entry of machine parameters, 141
Entry of motor data, 100
Environmental conditions, 31
− atmospheric pressure, 31
− pollution, 31
− site altitude, 31
− temperature, 31
− vibration resistance, 31
Error analysis, 232
− Via history buffer, 233
− via LECOM status word, 235
Error messages, 457
− Causes and remedies, 238
− causes and remedies, 238
− configuration, 194
− reset (TRIP−RESET), 246
Error response, 456
Event−controlled process data objects, 453
Examples
− reading parameters, 458
− Selection help for cable length / number of repeaters, 85
− writing parameters, 459
Executing a reset node, 178
Explanations, Code table, 363
External brake resistor, 464
− assignment, 464
− connection, 60
− type ERBD..., rated data, 464
− type ERBM..., rated data, 464
− type ERBS..., rated data, 465