Lenze ECSES Series - Page 473

Index 14
 473
EDBCSXS064 EN 4.0
Controller, 13
− application as directed, 18
− identification, 18
Controller enable, 143
Controller inhibit (CINH), DCTRL function block, 297
Current characteristics
− application example, 37
− device protection by current derating, 38
− rated output current, 35
Current controller adjustment, metrological determination
of electrical motor values, 150
Current derating, 38
Current load of controller, I x t monitoring, 207
Current load of the motor, I2 x t monitoring, 23 , 210
CW rotation, 121
Cyclic node monitoring (Node Guarding), 184
Cyclic process data objects, 451
D
Data telegram, 442
Data, general electrical, 32
DC bus
− connection, 53 , 55
− fuses, 56 , 466
DC−bus voltage
− monitoring functions, 214
− overvoltage, 214
− undervoltage, 214
DC−bus voltage monitoring (OU, LU), 214
DCTRL, 294
− axis module status, 299
− controller status
controller inhibit (CINH), 297
operation inhibit (DISABLE), 297
quick stop (QSP), 297
TRIP−RESET, 298
TRIP−SET, 298
Deceleration time
− Operating mode "Speed control", 327
− operating mode "Torque control", 351
Defining boot−up master, 175
Defining master in the drive system, 175
Definition of notes used, 30
Definitions of terms, 13
Device control, 294
Device protection, 27
Device protection by current derating, 38
Device status, 299
device status, 235 , 300
DFIN (master frequency input), 301
− configuring the input signal, 303
DFOUT (master frequency output), 304
− configuring the output signal, 306
Diagnostics, 225
− with Global Drive Control (GDC), 225
− with Global Drive Oscilloscope (GDO), 226
GDO buttons, 227
− with PCAN−View, 229
− with XT EMZ9371BC keypad, 228
Diagnostics codes, 187
DigIn (freely assignable digital inputs), 307
Digital frequency cables, 463
Digital frequency distributor, 463
Digital frequency input, 91
− features, 91
Digital frequency output, 91
− features, 91
Digital inputs, 69
− altering the terminal assignment, 122
− configuring, 121
− setting the direction of rotation, 121
− setting the polarity, 121
Digital inputs (DigIn), 307
Digital outputs, 69
− altering the terminal assignment, 122
− configuring, 121
− setting the direction of rotation, 121
− setting the polarity, 121
Digital outputs (DigOut), 308
Digital signals, list, 428
DigOut (freely assignable digital outputs), 308
Dimensions, 40 , 43 , 47
− axis module ECSCx..., 47
− axis module ECSDx..., 43
− axis module ECSEx..., 40
DIP switch, 170
Discharge current to PE, 32
Disposal, 22
Drive control, 294
Drive system, 13