Lenze Global Drive 9300 Servo PLC Series

Appendix
7-3
L MA9300PLC EN 1.4
P
Packing list, 1-2
Parameter
change, 5-12
Keypad, 5-10
Load parameter set, 5-13
Parameter set transfer, 2-2
PLC functionality, 3-3
Power connections, 4-13
Max. permissible cross-sections
for mains connection, 4-13
for motor connection, 4-17
Protection against contact, 4-10
Protection against inverse polarity, 4-20
Protection of devices, 2-2
Protection of persons, 2-2, 4-9
Insulation, 4-10
Residual-current circuit breaker, 4-9
Punching, 4-3
R
Rated data
200 % overcurrent, 3-5
Cable cross-sections, 3-7
Fuses, 3-7
Mains filter, 3-8
Types 9321 to 9325, 3-4
Types 9326 to 9332, 3-6
Reset, Fault message, 6-2
Residual hazards, 2-2
Residual-current circuit breaker, 4-9
Resolver connection, 4-30
S
Safety information, 2-1
Layout, 2-2
Other notes, 2-2
Warning of damage to material, 2-2
Warning of damage to persons, 2-2
Selection of the feedback system, 5-5
Servo.
Siehe Controller
Shielding
EMC, 4-33
Motor cable, 4-15
State bus, 4-25
Status messages, 6-1
Switch on, 5-4
Switching on the motor side, 4-17
T
Technical data, 3-1
Dimensions, 3-8
Electrical data, 3-4
Features, 3-1
General data/application conditions, 3-2
Temperature monitoring, 4-28
Thermal separation , 4-3
Tightening torques
Control terminals, 4-20
Power terminals, 4-13, 4-17
Troubleshooting, 6-1
U
Use, as directed, 1-3
User menu, 5-12
V
Vibrations, 4-1
Voltage drop, 4-14
W
Warranty, 1-3
Waste disposal, 1-3
Show/Hide Bookmarks