What to do if Lenze Media Converter shows earth fault?
If your Lenze Media Converter indicates an earth fault, check the motor and motor cable for a grounded motor phase or excessive capacitive charging current. Consider using shorter motor cables with lower charging current.
What causes Lenze Media Converter to stop (outputs U, V, W inhibited)?
The Lenze Media Converter may stop with inhibited outputs U, V, W due to a LOW signal at terminal 28. To resolve this, set terminal 28 to HIGH.
What to do if there is overvoltage on DC bus of Lenze Media Converter?
If you are experiencing overvoltage on the DC bus of your Lenze Media Converter, check the mains voltage, increase deceleration time or use dynamic braking option, or check the motor/motor cable for earth leakage (separate motor from controller).
General| Brand | Lenze |
|---|---|
| Model | TML |
| Category | Media Converter |
| Language | English |
Explanation of safety pictographs used in the manual and their corresponding meanings.
General safety rules, intended use, and compliance with directives for drive controllers.
Safety measures for handling, installation, and electrical connection of the drive.
Safety guidelines and warnings for operating the drive controller, including capacitor discharge and covers.
Specifies conformity, approvals, and environmental conditions for the drive.
Details electrical ratings for different drive models, including input and output current.
Covers physical dimensions, mounting instructions, and environmental considerations for installation.
Details requirements for electrical connections, EMC compliance, and wiring.
Specifies fuse types and cable cross-sections for EN 60204-1 and UL installations.
Provides a wiring diagram showing power and control connections for the drive.
Lists and explains the function of each control terminal for input and output signals.
Overview of how to set drive parameters using the keypad or EPM.
Information on the EPM for storing parameter settings and optional EPM programmers.
Detailed explanation of the parameter menu structure and common parameter settings.
Procedures for selecting Vector mode or Enhanced V/Hz mode for motor control.
Explains status indicators and error codes displayed by the drive.
Lists common errors, their causes, and recommended solutions for troubleshooting.
Details specific fault codes, their causes, and troubleshooting steps, including UL508C notes.
To Next Page