Friedrich Leutert GmbH & Co. KG 41
Digital Pressure Indicator DPI - Bedienungsanleitung
» Main menu «
Show data
Delete data
Configuration
» Main menu «
Measure engine
Show data
» Main menu «
Show data
Delete data
Configuration
}
}
}
}
» Delete data «
Cylinder no: 01?
No Yes
}
}
» Main menu «
Measure engine
Show data
» Delete data «
Main Engine
AUX Engine 1
}
» Delete data «
Main Engine
AUX Engine 1
AUX Engine 2
}
» Delete data «
Cylinder no: 01
Cylinder no: 02
}
Switch off the DPI handset by pressing the button for approx. 2 sec-
onds.
6.2 Delete data records in the handheld device
During the measurement, the DPI saves the measured values as data re-
cords which can be assigned to each individual cylinder. If you start a new
measurement, this data is overwritten. So it is not mandatory to delete old
measurement results before a new measurement is started. If you wish to
delete old results though, proceed as follows:
NOTE
Make sure that you have already downloaded and saved the mea-
surement data to the PC or that you no longer need the data.
1) Press the
button for approx. 1 second to switch on the handheld
device. Use the buttons or to switch between the lines.
2) If the ‘Delete data’ line is marked with the } arrow, press the but-
ton .
4) If the chosen engine is marked on the display with the } arrow, con-
firm the selection with button .
3) The saved engines are displayed. Scroll down this list with the verti-
cal arrow keys or .
5) The measured cylinders are displayed. Scroll with the keys or
until the cylinder to be deleted appears on the display or the selec-
tion ‘All cylinders’ is marked with the } arrow.
6) Delete the process with key [Yes] or cancel with [No] ab.
6.1) [Yes] The display changes back to the main menu. ‘Delete data’ ist
is marked with the } arrow.
6.2) [No] ends the deletion process
To Next Page
Loading...
Need help?
General
