Binary protocol type 1 Leuze electronic
70 BPS 8 Leuze electronic
This process toggles the data as long as the MM bit is set to 1, i.e., as long as the memory
contains marker information. The marker info does not depend on the BPS speed or on the
control's clock rate.
Figure 9.3: Function sequence for no marker inside the detection area
No marker inside the detection range
• The respective MM bit in the status byte remains set
until the last marker information has been retrieved.
• Old marker information remains in the memory.
Marker information is
retrieved.
Marker information is
not retrieved.
• The marker information is retrieved via the control
byte.
• The marker information in memory is deleted.
• The respective MM bit in the status byte is reset and
remains reset until another marker is detected.
New or old marker is detected.
To Next Page
