Leuze BPS 8 - Overview of the Parameter Structure

Leuze electronic Device parameters and interfaces
Leuze electronic BPS 8 51
TNT 35/7-24V
8.1.5 Overview of the parameter structure
Using the BPS Configuration Tool program, parameters can be changed via the service
interface. These parameters are separated into individual tabs in the Graphical Configura-
tion menu.
The following tabs are available:
Tab name Folder contents
Control
page 53
• Start mode
• Stop mode
• Maximum Polling Interval
Position Logging
page 54
• Resolution Host
• Integration time
• Preset mode
• Switch count direction
• Scaling factor
• Offset value
• Min measure length
• Max measure length
• Tolerance time
• Fault position output
Communication
page 59
• Baud Rate
• Data mode
• Protocol
• Address
Sensor
page 60
•Invert
• Mode
• Debounce time
• Delay on time
• Pulse duration
• Delay off time
• Function
Switch
page 62
• Activation
• Deactivation
• Pulse duration