Safety notices Leuze electronic
6 BPS 8 Leuze electronic
2.4 Working safely
Attention!
Access to or changes on the device, except where expressly described in this operating
manual, are not authorised.
Safety regulations
Observe the locally applicable legal regulations and the rules of the employer's liability insur-
ance association.
Qualified personnel
Mounting, commissioning and maintenance of the device may only be carried out by quali-
fied personnel.
Electrical work must be carried out by a certified electrician.
Attention, laser radiation!
Warning: The barcode positioning system BPS 8 operates with a red light laser of
class 2 acc. to EN 60825-1. If you look into the beam path over a longer time period,
the retina of your eye may be damaged!
Never look directly into the beam path!
Do not point the laser beam of the BPS 8 at persons!
When mounting and aligning the BPS 8, avoid reflections of the laser beam off reflec-
tive surfaces!
Heed the laser safety regulations according to DIN EN 60825-1 in their most current
version! The output power of the laser beam at the reading window is at most 1.3mW
acc. to EN 60825-1.
The BPS 8 uses a laser diode with low power in the visible red light range with an
emitted wavelength of 650nm.
Attention!
CAUTION! The use of operating and adjusting devices other than those specified here
or carrying out of differing procedures may lead to dangerous exposure to radiation!
Notice!
It is important that you attach the stick-on labels supplied to the device (notice signs and la-
ser emission symbol)! If the signs would be covered due to the installation situation of the
BPS 8, attach them close to the BPS 8 such that reading the notices cannot lead to looking
into the laser beam!
To Next Page
