Leuze BPS 8 - Page 55

Leuze electronic Device parameters and interfaces
Leuze electronic BPS 8 53
TNT 35/7-24V
8.1.6.1 Control
Figure 8.7: Control tab
Description:
The control manages timing of the position calculation by starting and stopping the
decoding. Control is performed depending on certain events such as the switching input or
time functions. Using parameters, the events which influence the states are determined.
Parameters
Parameter Description Value range Default Unit CR
Start mode
The start mode determines by
which event the position meas-
urement is started.
1: After initialisation
2: Via command or switching
input
2 –
Sensor
Stop mode
The stop mode determines after
which event the position meas-
urement is stopped.
2: Time (Polling Interval)
3: Time with retriggering
function (polling interval)
via command or switching
input
4: Via command or switching
input (the switching input
must be programmed for this
purpose)
3 –
Sensor
Maximum
Polling Interval
Time period after which the
scanning beam is switched off if
no polling takes place.
0 … 65'535 10'000 ms
a
h
b
h
c