26
4.3.2.3 IP Filter
The IP Filter setting can be found under this path: System> Security> IP Filter.
Using the IP filter, access to the IP Camera can be restricted by denying/allowing specific IP
addresses.
Enable IP Filter
Check the box to enable the IP Filter function. Once enabled, the listed IP addresses
(IPv4) will be allowed/ denied access to the IP Camera.
Select <Allow> or <Deny> from the drop-down list and click on the <Apply> button to
determine the IP Filter behavior.
Add/ Delete IP Address
Input the IP address and click on the <Add> button to add a new filtered address.
To Next Page
Loading...
