2. Hardware Installation
Unpack the printer server package and verify that all the items listed in the section 1.2 are
provided.
Connect the printer server to the printer you want to share on the network.
Connect the printer server to your network by attached the network cable to the UTP port of the
printer server.
Connect the power adapter to the printer server. The printer server will perform the
Power-On-Self-Test (POST) after it is powered on. During the POST, the Status and Ready LEDs
will be on. When the LEDs are unlighted, the printer server is ready.
NOTE: MUST use the power adapter shipped with the printer server, do NOT use any other
power adapter from any sources.
NOTE: To prevent the compatibility problem between printer server and a few printer, it is
recommended that you power on the printer server before the printer.
Wired Printer Server
LED Color Status Description
On
The LAN cable is connected to the Printer
Server.
Off No network connection.
LAN Green
Blinking
Network traffic transferring or receiving through
the LAN port.
On
Firmware is being upgraded to the Printer
Server. If the Printer Server is upgraded failed,
the LED will be lighted steadily.
Paper jam or paper out while printing.
Off No printing jobs.
Status Green
Blinking
The Printer Server is sending printing jobs to
printer.
On The Printer Server is ready.
Ready Green
Off
The Printer Server is failed to reboot.
Upgrade failed.
12
To Next Page
Loading...
